339
MASTERING
PROJECT SYSTEM DISK/USB MASTERING SAMPLING
SEQUENCE (Mixdown mode) screen
This is the Sequence screen in Mixdown mode.
To access this screen
•
➜➜
(turn on Mixdown mode)
➜
The screen that appears is essentially the same as
the Sequence screen when mixdown mode is Off
(the normal state).
Transport buttons
In the SEQUENCE (Mixdown mode) screen, the
transport buttons are used to create (record) the
mastering file.
PLAY
Plays the sequence. If you press this while the REC
indicator is blinking, mixdown will begin.
REC
Records. When you press this once, the indicator
(red) will blink, and you will be in mixdown-standby
mode. If you now press [PLAY], the indicator will
light steadily and mixdown will begin.
STOP
Stops sequencer playback or mixdown. If you
stopped mixdown, the message “Mixdown finished.
Go to Mastering?” will appear.
F-buttons
Close
Stops the playback of the audio file and then closes
LISTEN AUDIO FILE popup.
ECS05_manual_e.book 339 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
Need help?
General
