379
MIXER
IMPORT EFFECTS MIXER
MIXER (INSTRUMENT PART) screen
In this mixer screen you can set the level, pan, and
output bus.
To access this screen
•
➜
(Instrument part 1~8 mixer)
•
➜
(Instrument part 9~16 mixer)
The Audio Track Mixer screen and the Instrument
Part Mixer screen show the same parameters.
Explanation of each area
1.
Track / Part
Displays a portion of the name of the audio track or
instrument part.
The first few characters of the name are shown.
Subsequent characters are not displayed.
2.
Mute
Temporarily silences the track.
Range:
Off
, On
3.
DlyCho Send (Delay/Chorus Send Level)
Specifies the amount of signal sent to the
delay/chorus effect.
Range:
0
~127
4.
Reverb Send (Reverb Send Level)
Specifies the amount of signal sent to the reverb
effect.
Range:
0
~127
5.
Pan
Specifies the stereo position at which the signal is
output to the bus.
Range: L63~
0
~R63
6.
Level
Specifies the volume of each part.
Range: 0~
100
~127
You can use the eight sliders on the top panel to
adjust the Level parameter.
7.
Output
Specifies the signal output destination for each part.
F-buttons
Audio 1-8 (Audio Part 1~8)
Displays the
MIXER (AUDIO TRACK) screen
(p.
378).
Part 1-8 (Instrument part 1~8) /
Part 9-16 (Instrument part 9~16)
Displays the
MIXER (INSTRUMENT PART) screen
(p. 379) for channels 1~8 or 9~16.
AUX/Phrs/In (AUX bus / Audio phrase / Input)
Displays the
MIXER (AUX / FX / AUDIO PHRASE /
INPUT) screen
(p. 380).
Value
Explanation
Prtl
Follow the setting of the partial's
Out-
put Assign
(p. 276)
Mix
Output the sound to the Mix bus. The
sound will be output from Master and
Phones.
AUX1~
AUX4
Output the sound to an AUX bus.
MLT1~
MLT8
Output the sound to an
ANALOG MULTI OUTPUT bus (mono
output).
M1/2~
M7/8
Output the sound to a pair of ANALOG
MULTI OUTPUT buses (stereo output).
ECS05_manual_e.book 379 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
Need help?
General
