Web-based Configuration Guide Login
2
Username and password are not required at your first login and you can configure the bridge directly.
For device security, you are advised to set the management password after your first login to the web
management system. After the password is set, you need to enter the password when you log in to the web
management system again.
If you forget the Device IP address or password, hold down the Reset button on the device panel for more than
5s when the device is connected to the power supply to restore factory settings. After restoration, you can use
the default IP address and password to log in.
Caution
Restoring factory settings will delete all configurations of the device. Therefore, exercise caution when
performing this operation.
1.3 Quick Setup
1.3.1 Configuration Preparations
Connect the device to the power supply, and connect the device port to an uplink device with a network cable.
1.3.2 Procedure
1. Adding Device to Network
By default, users can perform batch settings and centralized management of all devices in the network.
Therefore, before starting configuration, you need to check and confirm the number of online devices and
network status in the network.
To Next Page
Loading...
Need help?
General