Testing Main Fuse
1. Disconnect main battery connection
2. Open the plastic box to access
main fuse.
3. Set DMM to Resistance
Measure where indicated below.
Ensure the nuts are tight, but not
overtightened, as this can cause the fuse
to twist and break.
If fuse is blown, replace only with the same physical
size and same Amperage and Voltage.
15
IMPORTANT: If the main fuse is blown, find the source of problem before replacing fuse
< Table of Contents
https://www.mouser.com/ProductDetail/Littelfuse/14256316122?qs=sGAEpiMZZMsh2y49K8ANrTdpOrToc%252bEOWEps5yIgKK0%3d
Available at Mouser.com:
To Next Page
Loading...
Need help?
General
