Pre and Post Repair Checklist
1. Set Parking brake. Jack rear tires approximately 2” off the ground and support securely with jack
stands.
2. Sit on mower.
3. Release the brake.
4. Turn main power key to “ON”. The Fuel Gauge/Hour meter should light up.
5. Push handles fully forward and hold. Rear wheels should be rotating forward
6. Pull handles rearward. Wheels should be rotatin reverse.
7. Pull PTO knob up, blade motors should run.
8. Turn off PTO, ensure blade motors stop.
9. Press Drive speed button. Verify drive speed should change between high and low.
10. Press Blade speed button. Verify blade speed should change between high and low
11. Press headlights button. Button should light and both headlights should come on.
12. Check that USB has power by verifying blue indicator light is on.
13 Remove yourself from mower seat. Beeping should be heard when there is no weight on chair.
14 Connect charger and verify charging LEDs are working correctly (green)
15 Attempt to start mower and drive away with charger connected. This should not be possible.
48
< Table of Contents
To Next Page
Loading...
Need help?
General
