1
Press [SETUP] and use [K / L] to select
“General Setting”, then press [OK].
“General Setting” menu will appear.
2
Use [K / L] to select “Clock”, then
press [OK].
“Clock Setting” menu will appear.
3
Use [K / L] to select calendar or time,
then press [OK].
Clock Setting
JAN / 29 / 2015 ( THU )
12 : 00 AM
Note
•
Your setting will be cancelled if you press [SETUP] before pressing [OK] at step 4.
•
Your clock setting will be lost if either there is a power failure or this unit has been unplugged for more than 30 seconds
when you set the clock manually.
•
For setting the day, year, hour, and minute, [the Number buttons] can also be used.
•
You can set the built-in calendar from the year 2012 up to 2062.
SETTING THE CLOCK
Set the clock before you try the timer programming. Follow these steps below.
4
Use [{ / B] to select an item to set, and
use [K / L] to select the contents to suit
your preference, then press [OK] when
you finish setting all the contents.
Clock Setting
JAN / 29 / 2015 ( THU )
12 : 00 AM
Your setting will be activated.
The clock start counting when you press [OK].
5
Press [SETUP] to exit.
To Next Page
Loading...
Need help?
General
