Sanyo FWZV475F User Manual

35
EN
35
EN
Recording
Playback Editing
Introduction
Connections Basic Setup Function Setup VCR Functions
Others Español
SATELLITE LINK
You can set the unit to start recording whenever it detects
the video signal from the external tuner.
Preparing for the satellite link timer recording:
Preparation on the tuner
•
Satellite link accepts only the connection from L1 (rear)
with the external tuner. (The connection from L2 cannot
read any signals from the external tuner.)
•
The external tuner should be equipped with some kind
of timer function. Using timer function of the tuner, set
it to output audio/video signals when it comes to the
time you want to start recording, and stop output audio/
video signals when it comes to the time you want to
nishrecording.Refertothetuner’smanualonhowto
set the timer.
•
Make sure to set the satellite link standby mode when
younishsetting.
1
Press [SETUP].
2
Use [K / L] to select “Timer
Programming”, then press [OK].
3
Use [K / L] to select “Satellite Link”,
then press [OK].
Timer Programming
Satellite Link
Timer Programming
4
Use [K / L] to select the time, media
and recording mode, then press [OK].
Satellite Link
To Standby Mode
5:00PM DVD SP
Start Mode
DVD
VCR
5
Use [K / L] to set the desired starting
time, then press [ B].
•
The hour can be selected from 1 to 12 with AM
or PM.
•
Repeat procedures in step 5 to set the desired
minutes.
•
If you wish to go back to the left, press [{].
6
Use [K / L] to select a recording media
(“DVD” or “VCR”), then press [ B].
7
Use [K / L] to select the recording
mode.
Refer to page 27 for details.
Instructions continue on the next page.

Sanyo FWZV475F Specifications

General

Brand	Sanyo
Model	FWZV475F
Category	DVD VCR Combo
Language	English