SETUPS
Press [C] if you are playing back a disc.
1
Press [SETUP] and use [K / L] to select
“General Setting”, then press [OK].
2
Use [K / L] to select “Video”, then
press [OK].
3
Use [K / L] to select a desired item,
then press [OK].
Progressive Scan
TV Aspect
Select Video
1
2
3
Submenu will appear.
4
Refer to
1
to
2
on this page and set
the selected item.
•
For
3
refer to page 37.
5
When you finish with setting, press
[SETUP] to exit.
Video
1
Progressive Scan (Default : OFF)
This unit is compatible with the progressive scan system.
The feature provides you with the higher definition images
than the traditional output system does. To utilize this
feature, you must set progressive scan mode to “ON”.
1) Use [K / L] to select “ON“, then press [OK].
Progressive Scan
ON
OFF
2) Use [{ / B] to select “Yes“, then press [OK].
Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.
NOTE :
Activate? Yes No
If there is no picture or picture is
distorted after selecting “Yes”,
Wait about 15 seconds for auto recovery.
3) Use [K / L] to select “Yes“ within 15 seconds (if
the picture is OK), then press [OK].
Your setting will be activated.
Note
•
If your TV is compatible with progressive scan (480p),
you are recommended to use the HDMI or component
video cable (commercially available) to connect this unit
to the TV. (Refer to pages 16-17.) If not, use the
RCA video cable and set the progressive scan to “OFF”
or press and hold [SETUP] for more than 3 seconds
during DVD playback.
•
When selecting “No” or not pressing any buttons on
the unit or remote control within 15 seconds at step 3,
progressive scan remains to be “OFF” (interlace scan).
2
TV Aspect (Default: 4:3 Letter Box)
You can select the TV aspect ratio to match the formats of
what you are playing back or watching digital TV
broadcasting with the unit and your TV screen (4:3
standard or 16:9 widescreen TV).
Use [K / L] to select a setting, then press [OK].
TV Aspect
4:3 Letter Box
4:3 Pan & Scan
16:9 Wide
If you have a standard TV:
Select “4:3 Letter Box”, so that black bars appear on
the top and bottom of the TV screen when playing
back a wide-screen picture. Select “4:3 Pan & Scan”
for a full height picture with both sides trimmed when
playing back wide-screen picture.
If you have a widescreen TV:
Select “16:9 Wide”.
To Next Page
Loading...
Need help?
General
