PUTTING INTO OPERATION ENGLISH
5. PUTTING INTO OPERATION
With respect to the technical character of this work, the mowing machine putting into operation is carried out by Your vendor (in accordance with the
instructions of the machine manufacturer).
5.1 CHECK OF OIL LEVEL IN ENGINE
Proceed according to the engine operating instructions, follow all the instructions stated in the chapter 7.1 "Summary of checks and maintenance".
5.2 CHECK OF ACCUMULATOR
Perform according to the accumulator operating instructions.
5.3 FILLING THE TANK WITH PETROL
The machine is transported without fuel for safety reasons.
Fill the tank only if the engine is turned off and is cold.
Use only the petrol with the octane number specified in the engine operating instructions.
Depending on the machine version, the tank is placed either under the front bonnet or in the left mudguard.
Open the tank cap slowly as there may be an overpressure of petrol vapours in the tank.
When refuelling, use a canister with a funnel.
Do not overfill the tank.
The petrol level height in tank can be controlled through a slot in the left-hand part of the seat column.
Always wipe dry the vicinity of the tank cap as well as the cap.
Clean also the whole tank regularly as the contingent impurities in the fuel may cause a failure.
When manipulating with the fuel, do not eat, smoke or use naked flame.
14
To Next Page
Loading...
Need help?
General
