SPARE PARTS ORDERING ENGLISH
8.1 SPARE PARTS ORDERING
We recommend to use only the original spare parts which ensure the safety and replaceability. Always order the spare parts at the authorized dealer or service
organization which are informed of the actual technical changes executed in the products during the manufacture. In the order always state the serial
number to enable the easy, quick and exact identification of the needed spare part. You will find the serial number recorded on the second page of this
manual cover. State also the year of the machine production which is included on the identification plate located under the seat.
8.2 GUARANTEE
The conditions of guarantee are specified on the certificate of guarantee which is always handed over with the product at the dealer.
9. AFTER-SEASON MAINTENANCE, MACHINE STORAGE
After the end of the season, or if the machine is not used for more than 30 days, it is advisable to prepare it immediately for the storage.
If the fuel stays in the tank without a motion for more than 30 days, sticky sediment may come into being.
This can have an adverse effect upon the carburettor and be a cause of the wrong function of the engine.
That is the reason for emptying the tank.
Recommended procedure of preparations for the mowing machine storage:
• Clean the whole machine thoroughly.
• Replace the faulty or worn out parts and tighten all loosened screws and nuts.
• Prepare the engine for the storage according to the engine operating and maintenance instructions.
• Lubricate all lubricating points according to the lubricating plan (see the chapter 7.6).
• Slacken the V-belt of the mowing mechanism drive (see the chapter 7.14)
• Take out the accumulator, clean it, refill it with distilled water up to the lower parts of filling holes rings and charge it fully.
Uncharged accumulator may freeze and burst. Store the accumulator, if need be, in a cold and dry place.
Charge the accumulator every 30 days and check its voltage regularly.
• Store the mowing machine covered in a clean and dry place.
The best way how to ensure the maximum serviceability of the mowing machine for the next season is an annual check and adjustment by the authorized service.
10. MACHINE DISPOSAL
The mowing machine user is obliged to dispose the machine after the end of its service life. This may be done in two ways:
a) To hand the machine over to a firm which is engaged in this activity (scrap yard, car cemetery, etc.)
You will receive the due document of handing the machine over to the disposal.
b)
T
o dis
pose the machine by Yourself. In this case we recommend to proceed in the following way:
• Carry out the disposal with utilization of the secondary raw materials in accordance with the applicable enactment on waste materials.
•
Dismantle the machine com
ple
t
ely
.
• Clean the parts which can be still utilized, conserve and store them for further use.
• Separate the other parts to the parts ecologically harmless and to the parts endangering the environment, e.g. the rubber parts (sealing rings),
r
esidues of lubricants in bearings or gearings. Ecologically har
mful com
ponents ha
ve to be treated in accordance with the applicable enactment
on waste materials valid in the country of the machine user, e.g. in the Czech republic it is the Law on waste materials no. 185/2001 Sb.
• Separate the disposed material according to the Waste catalogue in compliance with the applicable regulation. Ecologically harmless parts may
be treated as the scrap.
28
WARNING !!!
Never store the mowing machine with the full tank inside the buildings or in badly ventilated
spaces where there are fuel vapours, naked flame, sparking or ignition flames, furnace, central heating, dry rags, etc.
Handle the fuels and lubricants carefully as they are highly combustible, and a careless handling may cause serious burns to You or damage to the property.
Carry out the emptying of the tank only into the approved vessel outdoor without naked flame.
Seco GR
OUP a.s. continues all the time the de
v
elopment and im
pr
o
v
ement of all machines being manufactured, therefore the text and illustrations in this manual
may vary from the reality. No claims may be deduced of that. Printing, reproduction, publishing and translation (even partial one) is prohibited without consent
in writing by the Seco GROUP a.s. The changes are reserved.
To Next Page
Loading...
Need help?
General
