Step by step
Miscellaneous functions
114
Call charge consultation
1
If call charges for calls made have been established, the
system will have the ability to show the totals for the
calls on the displays of system telephones.
For the current call:
The call charge is shown on the display at the end of the
call (Standard)
If you would like to see the charges while the calls are
in progress, ask your system’s support technician to re-
quest activation of the AOCD (Advice of Charge During
the Call) facility from your local Carrier.
Depending on the Carrier, toll-free calls will also be
shown. Before or during a call the display will read
"FREE OF CHARGE".
When a call is transferred the call charge is assigned to
the extension that received the transfer.
For all calls that were made and have a remaining
balance:
First, the total charges are displayed (total for all calls
made). After five seconds the remaining balance is dis-
played, if the support technician has configured a Call
Charge limit.
N Press this key.
Select and confirm.
or
*65 Enter the code to enable call charge consultation.
[1] Call Charge ticketing must be programmed in the system (see
General programming - Call Charge in the Programming manual).
*65=SHOW CALL CHARGES?
To Next Page
Loading...
Need help?
General