Using the HiPath 1100 Features
19
System signaling tones
During feature configuration, the system uses the following signaling tones:
To n e M e a n i n g
Internal dialing tone The system is ready to receive and send call information.
Signaling tone Connection established. Ring signal is being applied to
phone number.
Dial tone Network accepted information request and is sending a re-
quest for further information.
Busy signal It indicates to the caller that the number is busy.
It is also used when the destination cannot be accessed
(e.g., invalid number).
External false signal The line tone heard is not the tone sent by the carrier.
Call waiting signaling tone It indicates to the user having a conversation that there is
another call ringing.
Call waiting tone for door
opener
It indicates to the user having a conversation that someone
is requesting the door opener to open the door.
Confirmation tone The procedure was successfully completed and accepted.
Rejection tone The procedure is invalid and was not accepted.
Override tone It alerts the user having a conversation that the call’s priva-
cy was violated (override).
Conference tone It indicates that a new participant joined the conversation.
Callback confirmation tone It confirms a callback.
Alert signal It alerts the called party when the speakerphone Auto-An-
swering and Paging features are activated.
Special dial tone Indicates that a service is activated (Night Service, elec-
tronic lock, Do not disturb, etc.)
Auto-answering tone After a Direct communication call is established.
To Next Page
Loading...
Need help?
General