A-1
ET 200S Interface Module IM 151/CPU
A5E00058783-01
Configuration Frame and Parameter
Assignment Frame for the ET 200S
By configuring the DP master you can specify which ID format should be used in
the configuration frame:
Configuration in STEP 7 with HWConfig: Integration of the IM 151/CPU slave,
during operation on the S7 master: Special ID format SKF
Configuration with another configuration tool: Integration of the IM 151/CPU
slave via the DDB: Normal ID format AKF
Configuration with
STEP 7
V5.1 or Higher
When you use an S7 master and configure and parameterize it with
STEP 7
, you
are supported during input by
STEP 7
and by the online help system.
You do not need the information in this appendix.
Configuration with Any Other Configuration Software
If you enter the address areas of the intermediate memory of the CPU using a
configuration and parameter assignment frame, you will find the information you
require for the IM 151/CPU in the following appendix.
When the configuration is displayed, the ID format in the configuration frame is
used.
Appendix Contents Page
A.1 Structure of the Configuration Frame (SKF) A-2
A.2 Structure of the Configuration Frame (AKF) A-4
A.3 Structure of the Parameter Assignment Frame A-6
A
To Next Page
Loading...
Need help?
General
