Siemens SIMATIC IPC477E PRO User Manual

Expanding the device and assigning the device parameters
7.2 Installing and removing a memory module
SIMATIC IPC477E PRO
Operating Instructions, 08/2017, A5E39912462-AA
79
7.2
Installing and removing a memory module
The procedures for installing and removing the memory module are the same for all device
variants.
The motherboard is equipped with one slot for an SO-DIMM DDR4 memory module. You
can use it to expand the memory capacity of the device to a maximum of 16 GB.
Note
Use only the memory modules
recommended by Siemens AG. You can find additional
information in the section "
Accessories (Page 14)".
Requirements
● The device is disconnected from the power supply.
● The device is open.
Procedure
NOTICE
ESD Directive
Note the protective measures required when working with ESD in the section "ESD
guideline (Page 108)".
Removal
1.
Press the marked latches towards the
outside.
The memory module tilts forward.
2.
Pull the memory module out of the slot in
the direction of the arrow.

Siemens SIMATIC IPC477E PRO Specifications

General

Brand	Siemens
Model	SIMATIC IPC477E PRO
Category	Industrial PC
Language	English