Setting Up and Operating the SIMATIC Rack PC IL 40 S
3-2
SIMATIC Rack PC IL 40 SManual
A5E00200171-01
3.1 Unpacking and Checking the Scope of Delivery
Unpacking the Rack PC
Unpack your Rack PC as follows:
1. Remove the device from the package.
2. Keep the original packing in case you have to transport the unit again sometime
in the future.
3. Please keep the supplied documentation in a safe place. It is required during
the initial start up and is part of the device.
4. Check the packing and its contents for any shipping or transport damage.
5. Check to make sure no components are missing. Also check the accessory
parts, which you can order separately.
6. Please inform your local dealer of any shipping or transport damages and of
outstanding items.
Recording the Serial Number (S VP) and the Ethernet address
7. Enter the serial number and the Ethernet address of your PC in the table of
the Getting Started. You can find the serial number (S VP) on the type label
attached to the rear of the device. The Ethernet address can be found in the
BIOS setup settings (key F2) under Info (key F1) > LAN Address.
The device can precisely be identified with the help of these numbers in case of
repairs or theft.
Enter the Microsoft Windows “Product Key” from the “Certificate of
Authenticity”
8. Enter the Microsoft Windows “Product Key” from the “Certificate of Authenticity”
(COA) in the table of the Getting Started. You will find the “Product Key” on the
inside of the front door. You need the Windows “Product Key” if you want to
reinstall the operating system.
To Next Page
Loading...
Need help?
General
