Technical Appendix
6.3 PLC user program for turning (UPGMTURN)
6-143
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
Spindle control
S Programmed and manual spindle start and stop (M3, M4 and M5)
S Spindle brake
S 2-stage spindle speed control
Toolholder control
S Manual tool change
S Programmed tool change
S Toolholder clamping time control
Coolant control
S Manual coolant control ON and OFF
S Programmed coolant control ON and OFF
S Manual lubricant control ON and OFF
S Time-controlled lubricant control ON and OFF
6.3.2 PLC machine data
The PLC machine data for configuring the user program are entered on the operator panel
under the Parameter menu. The PLC machine data for parameterizing the integrated user
program are described in the following Tables. During start-up of the SINUMERIK 802S, the
PLC machine data must be set according to the machine tool used. The parameters come into
effect with the next restart (POWER ON).
The function of all 16 inputs and 16 outputs of the SINUMERIK 802C basic variant can be set
by means of the following parameters:
MD14512 USER_DATA_HEX
Machine data VB45001000 – VB45001011
INDEX Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Input valid
[0] I 0.7 I 0.6 I 0.5 I 0.4 I 0.3 I 0.2 I 0.1 I 0.0
Input valid
[1] I 1.7 I 1.6 I 1.5 I 1.4 I 1.3 I 1.2 I 1.1 I 1.0
Inpuit 0-active
[2] I 0.7 I 0.6 I 0.5 I 0.4 I 0.3 I 0.2 I 0.1 I 0.0
Input 0-active
[3] I 1.7 I 1.6 I 1.5 I 1.4 I 1.3 I 1.2 I 1.1 I 1.0
Output valid
Lubricant control
To Next Page
Loading...
Need help?
General
