Technical Appendix
6.3 PLC user program for turning (UPGMTURN)
6-145
SINUMERIK 802S
6FC5 597–2AA00–0BP2 (01.02)
(Bit4) Override active
0 – not active
1 – active (V38030001.7=1)
MD14510 USER_DATA_INT
Machine data VW 45000000 – VW45000008
INDEX Int (2 bytes)
[0] Toolholder positions (4 or 6)
[1] Toolholder clamping time (unit: 100 ms)
[2] Spindle brake hold time (unit: 100 ms)
[3] Lubrication interval (unit: 1 min.)
[4] Lubrication time (unit: 100 ms)
MD14510[0]: toolholder positions:
The number of positions must be 4 or 6; otherwise, no toolholder is detected.
MD14510[1]: toolholder clamping time:
Toolholder retraction time default value for clamping, a multiple of 100 ms.
MD14510[2]: Spindle brake hold time:
Time required to activate the spindle brake, a multiple of 100 ms.
The spindle brake is activated either by Spindle Stop from the machine control panel or by
the M05 function in the NC part program.
MD14510[3]/[4]: Lubrication interval / time:
For automatic lubrication, a multiple of 1 minute must be entered for the lubrication interval
and a multiple of 100 ms for the lubrication time.
6.3.3 Input/output configuration
The following tables show the assignments of the inputs/outputs and of the machine control
panel keys, as well as their function in the UPGMTURN. Any signals not needed can be mas-
ked via PLC machine data.
Note
When installting the SINUMERIK 802S on your machine, make absolutely sure that the input/
output assignment is carried out as described in the Table.
To Next Page
Loading...
Need help?
General
