Siemens SINUMERIK 808D ADVANCED Parameter Manual

41100 JOG_REV_IS_ACTIVE - -
- JOG mode: revolutional feedrate / linear feedrate BYTE Immediately
-
808d-me42 - 0x0E 0 - 1/1 M
808d-me62 - 0x0E 0 - 1/1 M
808d-te42 - 0x0E 0 - 1/1 M
808d-te62 - 0x0E 0 - 1/1 M
808d-mte40 - 0x0E 0 - 7/7 U
808d-mte60 - 0x0E 0 - 7/7 U
Description: Bit 0 = 0:
The behavior depends on the following:
- in the case of an axis/spindle:
on the axial SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE
- in the case of a geometry axis with an active frame with rotation:
on the channel-specific SD42600 $SC_JOG_FEED_PER_REV_SOURCE
- in the case of an orientation axis:
on the channel-specific SD42600 $SC_JOG_FEED_PER_REV_SOURCE
Bit 0 = 1:
A JOG motion with revolutional feedrate shall be traversed depending on the master
spindle.
The following must be considered:
- If a spindle is the master spindle itself, it will be traversed without revolutional
feedrate.
- If the master spindle is in stop position and if SD43300
$SA_ASSIGN_FEED_PER_REV_SOURCE (with an axis/spindle) or SD42600
$SC_JOG_FEED_PER_REV_SOURCE
(with a
geometry axis with an active frame with rotation,
or with an orientation axis) = -3, traversing will be carried out without revolutional
feedrate.
Bit 1 = 0:
The axis/spindle, geometry axis or orientation axis will be traversed with
revolutional feedrate even during rapid traverse (see bit 0 for selection).
Bit 1 = 1:
The axis/spindle, geometry axis or orientation axis is always traversed without
revolutional feedback during rapid traverse.
Bit 2 = 0:
The axis/spindle, geometry axis or orientation axis is traversed with revolutional
feedrate during JOG handwheel travel, too (see bit 0 for selection).
Bit 2 = 1:
The axis/spindle, geometry axis or orientation axis is always traversed without
revolutional feedrate during JOG handwheel travel.
Bit 3 = 0:
The axis/spindle is traversed with revolutional feedrate during DRF handwheel travel,
too (see bit 0 for selection).
Bit 3 = 1:
The axis/spindle is always traversed without revolutional feedrate during DRF
handwheel travel.
NC setting data
Parameter Manual
302 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English