Siemens SINUMERIK 808D ADVANCED Parameter Manual

DB3000 Mode signals to NCK [r/w]
PLC -> NCK interface
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Reset Mode
change
block
Mode
JOG MDI AUTO
1 Single block Machine function
Type A Type B REF
2 Machine function
1)
Continuous
traversing
Var. INC 10000 INC 1000 INC 100 INC 10 INC 1 INC
3
1)
To use the machine function signals in DB3000.DBB2, you must set the "INC inputs in the
operating-mode signal range active" signal (DB2600.DBX1.0) to "1".
DB3100 Mode signals from NCK [r]
NCK -> PLC interface
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Reset 808 READY Mode
JOG MDI AUTO
1 Active machine function
REF
2 Machine function
Continuous
traversing
active
Var. INC ac‐
tive
10000 INC
active
1000 INC
active
100 INC ac‐
tive
10 INC ac‐
tive
1 INC active
3
6.8 Channel signals
6.8.1 Signals to NC channel
Control signals to NC channel
DB3200 Signals to NCK channel [r/w]
PLC -> NCK interface
Byte
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Activate
test run fee‐
drate
Activate
M01
Activate
single block
1)
Activate
DRF
Activate tra‐
verse for‐
wards
Activate tra‐
verse back‐
wards
PLC user interface
6.8 Channel signals
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 469

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English