MD20060 $MC_AXCONF_GEOAX_NAME_TAB (geometry axis name in the channel [GEOAxisno.]
MD20080 $MC_AXCONF_CHANAX_NAME_TAB (channel axis name in the channel [Channelaxisno.]
10050 SYSCLOCK_CYCLE_TIME N01, N05, N11 G3, G2, R1
s System clock cycle DOUBLE PowerOn
SFCO
808d-me42 - 0.002 0.001 0.008 0/0
808d-me62 - 0.004 0.001 0.008 0/0
808d-te42 - 0.002 0.001 0.008 0/0
808d-te62 - 0.004 0.001 0.008 0/0
808d-mte40 - 0.002 0.001 0.008 7/2
808d-mte60 - 0.004 0.001 0.008 7/2
Description: Basic cycle time of the system software
The cycle time settings of cyclical tasks (position controller/IPO) are multiples of
this basic cycle.
For PROFIBUS/PROFINET:
In the case of systems with a PROFIBUS DP connection, this MD corresponds to the
PROFIBUS
DP cycle
time. This time is read from the configuration file (SDB-Type-2000)
during startup and written to the MD.
This MD can only be changed via the configuration file.
Note:
Reducing this MD can result in an automatic correction of
MD10064 $MN_POSCTRL_CYCLE_DESVAL_DELAY
that cannot be undone by a subsequent increase!
Details:
The basic cycle is incremented in multiples of units of the measured value sampling
cycle. When the system powers up, the entered value is automatically rounded to a
multiple of this incrementation.
Note:
Discrete timer division ratios can give rise to the entered value producing a value
that is not an integer after a Power OFF/ON.
For example:
Input =0.005s
after power OFF/ON =0.00499840
or
Input =0.006s
after power OFF/ON =0.0060032
10064 POSCTRL_CYCLE_DESVAL_DELAY N01, N05 G3
s Clock skew of the DMA for the setpoints DOUBLE PowerOn
-
808d-me42 - 0.0 0.000 0.008 ReadOnly
808d-me62 - 0.0 0.000 0.008 ReadOnly
808d-te42 - 0.0 0.000 0.008 ReadOnly
808d-te62 - 0.0 0.000 0.008 ReadOnly
808d-mte40 - 0.0 0.000 0.008 7/2
808d-mte60 - 0.0 0.000 0.008 7/2
Description: For SINAMICS-Integrated only:
Only relevant to operation with SINAMICS-Integrated drives on SOC modules.
Offset of the output of the setpoints via DMA in relation to the PROFIBUS DP cycle.
Machine data
3.2 General machine data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 33
To Next Page
Loading...
Need help?
General
