60
Connecting Up the Switcher
Chapter 3 Preparations
The following messages appear in the display panel during boot mode.
Now Initializing…Please Wait…: Initializing
Now initial communication started.: Establishing communication
between the control panel and the processor unit
3
Pull the fader lever once from the top of its range all the way to the bottom.
4
Power on the peripheral devices.
To power off
• Always use the following procedure to power off. If you power off without
carrying out the correct procedure, the current control panel settings will not
be saved, and the switcher may become unable to boot normally.
• If you have connected a USB flash drive, remove it before powering off.
Tip
Display panel
Notes
To Next Page
Loading...
Need help?
General
