137
Customizing DME Effects
Chapter 5 Adjusting Wipes and Keys
Change aspects
Crop sub menu parameters
You can crop the top, bottom, left, and right edges of
images by specified amounts. To do so, adjust the
following parameters.
Crop example
Setup sub menu parameters
Set the following parameters.
a) When you are setting up a transition
b) When you are setting up a key
Adding Borders to Images
Use the sub menus of the Border sub menu to do the
following.
Operation Knob Parameter Settings
Specify an
aspect in the X
axis direction.
F2 X (Aspect X) 0.000 to 8.000
Specify an
aspect in the Y
axis direction.
F3 Y (Aspect Y) 0.000 to 8.000
Specify an
aspect in the Z
axis direction.
F4 Z (Aspect Z) 0.000 to 8.000
Change aspect in the X axis direction
Change aspect in the Y axis direction
Change aspect in the Z axis direction
Crop width
Crop width
Operation Knob Parameter Settings
Specify the crop
width for the left
side.
F1 L (Left Side) 0.0 to 100.0
Specify the crop
width for the right
side.
F2 R (Right Side) 0.0 to 100.0
Specify the crop
width for the top
side.
F3 T (Top Side) 0.0 to 100.0
Specify the crop
width for the
bottom side.
F4 B (Bottom
Side)
0.0 to 100.0
Operation Knob Parameter Settings
Enable or disable
DME (same
function as the
DME ENABLE
button in the
KEYER block
(see page 14)).
F1 DME Off: Disable
DME
On: Enable
DME
a)
On-woK:
Disable DME
for keys
b)
On-w/K: Enable
DME for
keys
b)
Enable or disable
global
coordinates.
F2 Glbl (Use
Globals)
On: Enable
Off: Disable
Sub menu Operation
xxx Border Color
a)
(Border Color)
Select whether to add a border
to an image, and adjust the color
of the border, if added.
M/E DME Inner Width
b)
,
Keyer Bord Inner Wid
c)
(Inner Width)
Adjust the widths of the inner
sides of the border.
M/E DME Outer Width
b)
,
Keyer Bord Outer Wid
c)
(Outer Width)
Adjust the widths of the output
sides of the border.
M/E DME Border Soft
b)
,
Keyer Bord Softness
c)
(Softness)
Adjust the softness of the inner
and outer sides of the border.
To Next Page
Loading...
Need help?
General
