101
GB
Adjusting Settings
x Main/Sub
Sound of the main language will be output
through the front left speaker, and sound of the
sub language will be output through the front
right speaker simultaneously.
x Main
Sound of the main language will be output.
x Sub
Sound of the sub language will be output.
Lets you compress the dynamic range of the
soundtrack. This may be useful when you want
to watch movies at low volumes late at night.
Dynamic range compression is possible with
Dolby Digital and Dolby TrueHD sources
only.
x Off
The dynamic range is not compressed.
x Auto
The dynamic range is compressed
automatically when there is a flag in the sound
source that recommends the Dynamic Range
Compressor.
x On
The dynamic range is compressed as intended
by the recording engineer.
Note
• This function does not work in the following case.
– “MULTI IN” is selected.
Lets you turn the low-pass filter for the
subwoofer output on or off. You can set the
function for each input to which an audio input
jack is assigned independently. Turn the
function on if you connect a subwoofer
without the crossover frequency function.
x Off
Does not activate the low-pass filter.
x On
Always activates the low-pass filter with a
cutoff frequency of 120 Hz.
Note
• This function does not work in the following cases.
– “MULTI IN” is selected.
– “2ch Analog Direct” is being used.
Lets you delay the output of audio to minimize
the time gap between audio output and visual
display.
This function is useful when you use a large
LCD or plasma monitor or a projector.
You can set the function for each input
independently.
x HDMI Auto
The time gap between audio output and visual
display for the monitor connected via an
HDMI connection will be adjusted
automatically based on the information for the
TV. This feature is available only when the
monitor supports the A/V Sync function.
x 0 ms – 1200 ms
You can adjust the delay from 0 ms to
1200 ms* in 10 ms intervals.
* The maximum delay may be limited to the lower
value, depending on the audio stream.
Note
• This function does not work in the following case.
– “MULTI IN” is selected.
Lets you specify the input mode for the digital
signal input to the DIGITAL IN jacks or
HDMI IN jacks.
Dynamic Range Compressor
Subwoofer Low Pass Filter
A/V Sync (Synchronizes audio
and video output)
Decode Priority (Digital audio
input decoding priority)
continued
To Next Page
Loading...
Need help?
General
Weight and Dimensions
