130
GB
5 Press the button on the remote
control to be learned from to
transmit the remote control
code.
While the remote control of the receiver is
receiving the signal, the input button
selected in step 2 turns off.
The RM SET UP button flashes twice,
then the learning process is completed.
When the learning process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
6 Press RM SET UP to finish the
learning function process.
To cancel learning
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
However, after performing step 3, you cannot
cancel the settings even if you press RM SET
UP. In this case, after leaving the remote
control untouched for 10 seconds, press RM
SET UP to cancel the settings.
When selecting a learned input,
press the button used to learn that
function.
To erase the learned code
1
Press FAVORITES while pressing RM
SET UP.
2 Press the input button for which you
want to clear the setting.
The input button flashes. (The RM SET UP
button remains lit.)
3 Press ?/1 for more than 1 second.
The input button flashes twice, repeatedly.
4 Press the button which learned the
command to clear the stored setting.
The RM SET UP button flashes twice, then
the clearing process is completed.
When the clearing process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
5 Press RM SET UP to finish the erasing
process.
Clearing the memory of
the multifunction remote
control
Using a command that has been
learned
?/1
AV ?/1
RM SET
UP
To Next Page
Loading...
Need help?
General
Weight and Dimensions
