45
GB
Getting Started
6: Preparing the receiver
and the remote control
Connect the supplied AC power cord (mains
lead) to the AC IN terminal on the receiver
firmly, then connect the AC power cord (mains
lead) to a wall outlet.
A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed
be connected this way. This is not malfunction.
Press ?/1 to turn on the receiver.
You can also turn on the receiver using ?/1 on
the remote control.
When you turn off the receiver, press ?/1
again. “STANDBY” flashes on the display
window. Do not disconnect the AC power cord
(mains lead) while “STANDBY” is flashing.
This may cause a malfunction.
To save the power in standby
mode
Set “Control for HDMI” (page 108), “Pass
Through” (page 108), “Network Standby”
(page 110), and “RS232C Control” (page 114)
to “Off” or “Auto” (for “Pass Through” only),
and turn off the power for zone 2/zone 3.
If “Control for HDMI” (page 108), “Pass
Through” (page 108), or “Network Standby”
(page 110) is set to “On,” or the power for zone
2 or zone 3 is turned on, the lamp above ?/1
lights up in amber.
Note
The top of the receiver may become hot while the
receiver is in standby mode. This condition occurs
because current is flowing in the internal circuits of
the receiver. This is not a malfunction.
Connecting the AC power cord
(mains lead)
AC IN terminal
To the wall outlet
AC power cord
(mains lead)
(supplied)
Turning on the receiver
?/1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
