143
GB
Additional Information
The remote control does not function.
• Point the remote control at the remote
sensor on the receiver (page 10).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• When you start operating the receiver,
make sure to press AMP on the remote
control first. Otherwise, operations that
follow may not be aimed at the receiver.
Then select the devices you want to use by
pressing one of the input buttons.
• Make sure that the command modes of the
receiver and the remote control are the
same. If the command mode of the
receiver and the remote control are
different, you cannot operate the receiver
with the remote control (page 86).
• Make sure you select the correct input on
the remote control.
• When you operate a programmed non-
Sony equipment, the remote control may
not function properly, depending on the
model and the maker of the equipment.
The RM SET UP button flashes and you
cannot set up Macro Play (page 127) or
the remote control cannot learn a
remote control code (page 129).
• When the RM SET UP button flashes five
times, replace the batteries with new ones.
If the trouble is other than one of the cases
described above and the trouble is not solved
even if you wait for a while, perform either of
the operations below.
• Press ?/1 on the remote control to turn the
receiver off and then on again.
• Hold down ?/1 on the receiver until the
lamp above the button flashes in green to
reboot the receiver.
You can check the status of the receiver by the
message. See the following to solve the
problem. If any problem persists, consult your
nearest Sony dealer.
PROTECTOR
The receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver and turn on the power again.
SPEAKER SHORTED
Irregular current is output to the speakers
due to a short circuit on the speaker
terminals. The receiver will automatically
turn off after a few seconds. If the protective
device on the receiver is activated due to a
short-circuit problem, turn off the receiver.
Check the connection of the speakers and
turn on the power again.
FAN STOPPED
Check that the ventilation hole on the top of
the receiver is not blocked.
“A new software version is available.
Please go to the “Setup” section of the
menu and select “Network Update” to
perform the update.” appears on the TV
screen.
See “Network Update” (page 114) to update
the receiver to a newer software version.
Video cannot be output from this jack.
• If you use the receiver in the main zone,
connect the receiver to a TV via an HDMI
cable.
• If you connect the receiver to a TV via a
video cord, set “Playback Resolution” to
“480i/576i” (page 106).
• If you connect the receiver to a TV via a
component video cord, set “Playback
Resolution” to a parameter appropriate to
your TV (page 106).
Remote control Error messages
continued
To Next Page
Loading...
Need help?
General
Weight and Dimensions
