56
Chapter 2 Menu
Cancelling the Remote Control
Mode
To cancel the remote control mode, press the
ADDRESS button.
Exiting the ADDRESS Menu
To exit the ADDRESS menu, press the ADDRESS
button or the MENU button.
Short-cut Function in the
ADDRESS Menu
When selecting the monitor, short-cut function will
enable to select the target monitor without using the
items in the ADDRESS menu. The operation
procedure is as follows.
To select the monitor in the SINGLE mode
1 Press the ADDRESS button.
2 Press the address number of the target monitor.
Press one digit address number on the numeric
keypad when it is from 1 to 9.
Press three digits address number (press 0 button
and then press the two-digit address number) when
it is from 10 to 99.
To select the monitors in the GROUP mode
1 Press the ADDRESS button.
2 Press the F1 button.
3 Press the group number of the target monitor.
Press one digit group address number when it is
from 1 to 9.
Press three digits group address number (press 0
button and then press the two-digit group number)
when it is from 10 to 99.
To select all the monitors in the ALL mode
1 Press the ADDRESS button.
2 Press the F2 button.
Selecting the Monitor to Control — ADDRESS Menu
To Next Page
Loading...
Need help?
General