103
To insert or remove the key gradually with a mix or
wipe, press the [AUTO TRANS] button for the
corresponding key or operate the fader lever. Pressing
the [AUTO TRANS] button executes the transition at
the preset transition rate.
To insert/remove the key instantaneously, press the
[KEY ON] button for the corresponding key.
You can also set the key delegation button for
operation by the fader lever.
For details, see “Setting the Buttons and Fader Levers
on the Key Fader Control Block” (page 409).
Selecting Independent Key
Transition Type
There are two ways of setting the transition type: using the
Flexi Pad control block or using the Transition/Video
Process menu for the target key on the M/E or PGM/PST
bank.
You can also set the transition type using independent key
transition operations on the key fader control block (see
page 102).
When the independent key transition mode is set to
[Independ] in the <Key Transition> group of the
Engineering Setup >Switcher >Transition menu (7334),
you can select the transition type used when inserting and
removing a key.
Setting the independent key transition
type (Flexi Pad control block)
If the independent key transition mode is set to [Independ],
setting the transition type while a key is not inserted will
set the transition type for key insertion, and setting the
transition type while a key is inserted will set the transition
type for key removal.
1
In the Flexi Pad control block of the target switcher
bank, press the [KEY] button.
This switches the memory recall section to
independent key mode.
2
Select the target key.
Press one of the [KEY1] to [KEY8] buttons, turning it
on.
3
Set the transition type.
Press the [MIX], [WIPE], or [DME WIPE] button,
turning it on.
To check the independent key transition type
The specified independent key transition type is displayed
in the independent key transition display section in the
transition control block or independent key transition
control block.
The transition type for keys assigned to the key delegation
buttons are shown on the display in the key fader control
block.
• The transition types are indicated by the letter “M”
(mix), “W” (wipe), “D” (DME wipe), and “C” (cut).
• The transition type is not displayed when the transition
rate display is set to timecode display mode.
Setting the independent key transition
type (menu)
This section describes setting the transition type for key 1
on the M/E-1 bank as an example.
1
Open the M/E-1 >Key1 >Transition/Video Process
menu (1117).
2
Select the transition type in the <Transition Type>
group.
If the independent key transition mode is set to
[Independ], select the transition type for key insertion
in the <ON Transition Type> group and the transition
type for key removal in the <OFF Transition Type>
group.
Setting the Independent Key
Transition Rate
There are two ways of setting the transition rate: entering
a value using the numeric keypad control block or using
the Transition/Video Process menu for target key on the
M/E or PGM/PST bank.
You can also display the transition rate, independent key
transition rate, and fade-to-black transition rate for each
bank, and change the settings (see page 190).
When the independent key transition mode is set to
[Independ] in the <Key Transition> group of the
Engineering Setup >Switcher >Transition menu (7334),
you can select the transition type rate when inserting and
removing a key.
Note
Notes
To Next Page
Loading...
Need help?
General
