5-13
OPERATING YOUR VEHICLE
69TB-01E
• Normally, the immobilizer/keyless push
start system warning light should go out
and the master warning indicator light
should stop blinking shortly after the
remote controller is brought back inside
the vehicle. If they remain lit and blinking,
change the ignition mode to LOCK (OFF)
by pressing the engine switch and then
perform the engine starting operation.
Refer to “Starting engine” (P.5-13).
• Always keep the remote controller with
you as the driver.
Starting engine
Starting engine
55T050040
1) Check that the parking brake is set fully.
2) Turn off such loads as the headlights
and air conditioning system to facilitate
starting of the engine.
3) Manual transmission vehicle:
Shift into “N” (Neutral). Hold the clutch
pedal and brake pedal fully depressed.
CVT vehicle:
If the gearshift lever is not in “P” (Park)
position, shift into “P” (Park). Hold the
brake pedal fully depressed.
4) The “PUSH START SWITCH” message
will appear in the information display in
the instrument cluster.
82K254
5) With your foot taken off the accelerator
pedal, push the engine switch (1).
When the engine is started, the starter
motor will automatically stop.
• Even if you fail to start the engine,
the starter motor will stop turning
automatically after approximately 12
seconds. In this case, press the
engine switch to select LOCK (OFF)
mode and restart the engine.
• If there is a problem with the system,
the engine will not start automatically
even if the switch is pressed. In case
the starter motor does not turn or
stops immediately, start the engine
by the following procedure.
a. Press the engine switch to select
the ON mode.
(1)
To Next Page
Loading...
Need help?
General
