7-9
OTHER CONTROLS AND EQUIPMENT
69TB-01E
Accessory socket
Center console
69T070090
• Each accessory socket in the above fig-
ure is a typical example; the actual
equipment depends on the vehicle type.
The accessory socket will work when the
engine switch is in ACC or ON mode.
This socket can be used to provide 12 volt/
120 watt/10 ampere power for electrical
accessories.
When using the accessory socket, open
the rubber cap (1).
(1)
WARNING
When the accessory socket is not in
use, closed the rubber cap. If any for-
eign material enters the accessory
socket, it may cause a malfunction or
short circuit.
NOTICE
• To prevent the fuse from being
blown, when using sockets at the
same time, do not exceed the total
combined power capacity of 12
volt/120 watt/10 ampere.
• If you use the accessory socket
while the engine is stopped, the
lead-acid battery may discharge.
Also, if you use the accessory
socket for a long time while the
engine is in the idling condition,
the lead-acid battery may dis-
charge.
(Continued)
NOTICE
(Continued)
• Check that the cap remains on the
socket when the socket is not in
use.
• Use of inappropriate electrical
accessories can cause damage to
your vehicle’s electrical system.
Check that any electrical accesso-
ries you use are designed to plug
into this type of socket.
• When the engine switch is in LOCK
(OFF) mode, the audio or naviga-
tion system may not turn off or the
keyless entry system may not
work. These situations may occur
because of the electrical equipment
which is connected to the acces-
sory socket. In this case, discon-
nect the electrical equipment from
the accessory socket and check
whether the situations are
improved. If the problem persists,
ask an authorized SUZUKI dealer or
a qualified workshop for inspec-
tion.
To Next Page
Loading...
Need help?
General
