10
| Drawings, diagrams, guides and instructions for the use, maintenance and repair
D.5 Ordinary automatically operation – only manual operation by new parameters
The unit is operating fully automatically and manual operation includes only selection of new parameters via the but-
tons on the hand terminal. The hand terminal is connected by a cable to the controller in the cabinet. 10 meters of cable
is delivered with the unit and the customer has the possibility to replace this cable with an identical type of cable that is
up to 100 meters long. The alternative is that the controller is connected to a BMS system with the ability to select new
parameters via PC, tablet or SmartPhone.
D.6 Warnings about dangers
Pictograms according to EN1886 about
Warning
Warning about danger by rotating parts
Warning
Warning about danger by electricity
Warning
Warning about danger by heat
Warning
Disregards of instructions shown on warning signs are connected by risk for injury or damage on material.
E Drawings, diagrams, guides and instructions for the use, maintenance and
repair
All Geniox units with integrated control system are manufactured in compliance with the EC Declaration of Conformity
and they are CE marked as machines. Unique Declaration with production number of the machine is an integral part of
the machine – enclosed as Annex 1to this manual. If the buyer carries out changes or adds components in or on the ma-
chine, the buyer must issue a new EC Declaration of Conformity and a new CE marking of the machine.
To promote correct use of the machines, the below-mentioned instructions are an integral part of the machine:
• Unique drawings, data and description of functions for the delivered unit – Annex 2
• Wiring diagrams – Annex 16
• Operator’s Guide – Annex 17
• Instructions for use of the machine – chapter K in this manual
• Instructions about adjustment and maintenance – chapter R in this manual
• Safety during adjustment and maintenance – chapter S
F Employees in charge of operation/control/maintenance
The units are constructed and built with a fully integrated control system. After start-up and hand-over from installer to
operators, the unit operates fully automatically.
Indications of operating status as well as indication of faults are visible in the display and on the LEDs at the hand termi-
nal. The operators can enter new parameters in the controller via the buttons on the hand terminal. Alternatively, the
controller can be connected to a BMS system so that new parameters can be selected via PC, tablet or Smartphone.
The operators do not need to open inspections doors for the operation.
Skilled technicians must carry care out maintenance as well as repairs.
G Intended use and range of applications
The air handling units are intended for the transport and treatment of air between -40 °C and + 40 °C The units are ex-
clusively for comfort ventilation. The units are not for environments that exceed the corrosion class C4 according to EN
ISO 12944-2.
Intended applications for the units are:
output |
To Next Page
Loading...
Need help?
General
