TCS 3000 User Manual

12
Total Control Systems www.tcsmeters.com
SELECT PRINTER
None No printer is to be used, will remove the communication for printing.
Remote Client Registers must select Remote to allow you to use a printer remotely when con
nected to the register through a daisy chain RS485 serial communication.
Epson TMU 220/295 Epson slip or roll printer driver installed
Citizen CMP30 Citizen printer driver installed
Printek Printek printer driver installed
DDP-350 Stimare printer driver installed
Blaster Blaster printer driver installed
Blaster_DLXI Blaster printer driver installed
Blaster_CR Blaster printer driver installed
PRINTER HOST
Printer Host is used when you plan to daisy chain multiple TCS 3000 registers together for
a single printer. Host is the primary meter and the Clients are all registers following the
Host. Client registers must select the Remote printer.
Enable/Disable Host To Enable or Disable the Printer Host, highlight Enable or Disable and select
ENTER
- Enable will allow you to use Printer Host
- Disable will not allow you to use Printer Host
Clients Address Range Use the keypad to define the starting and ending address range of registers on the
daisy chain (See pages 36-37 for instructions on how to daisy chain).
4) REGIONAL SETTINGS
DATE & TIME
Date Format MMMM DD, yyyy
MM/dd/yyyy
yy/MM/dd
dd/mm/yyyy
dd/mm/yy
Time Format 24 Hour Clock
12 Hour Clock AM/PM
Set Date Year — Format YYYY
Month — Select Month
Date — Select Date
Set Time Format time: Hours.Minutes.Seconds (HH.MM.SS)
NOTE: Hours - 24 hr. clock and a period must be used as your divider
Time Source BIOS source time and date
Controller source time and date
DECIMAL SYMBOL Select a ‘.’ period or a ‘,’ comma and press ENTER
5) DELIVERY SETTINGS
PRESET SETTINGS
Enable Preset Utilizing the preset will request a preset amount before a delivery begins. After selection,
press ENTER to complete setting.
Enable Preset Enable or disable preset
Preset By Price Enable or disable preset by Price
Gross Preset Enable or disable preset in GROSS VOLUME
Net Preset Enable or disable preset in NET CORRECTED VOLUME
Retain Preset Enable or disable preset for repeat BATCH presets
Preset Top Off Enable for preset batch and Pause. Press START to continue delivery.
NOTE: Each Preset Setting requires configuration under Product Settings for S1 and S2 operation.
(See page 20 for instructions on how to configure Preset valve closure).

TCS 3000 Specifications

General

Brand	TCS
Model	3000
Category	Measuring Instruments
Language	English