Setup
Wireless Channel — Select the appropriate channel that corresponds to your network
settings. You should assign different channels for each access point to avoid signal
interference.
TIP:
Select Auto for Wireless Channel to allow your Wireless Gateway to select the best
possible channel for your wireless network.
Wireless Mode — Select the wireless mode to limit the type of wireless devices that
can connect to the network. Options are:
• 802.11b only: Only 802.11b wireless devices can connect to the network.
• 802.11g + 802.11b: Only 802.11g and 802.11b wireless devices can connect
to the network.
• 802.11g only: Only 802.11g wireless devices can connect to the network.
• 802.11n + 802.11g + 802.11b: All 802.11n, 802.11g, and 802.11b wireless
devices can connect to the network.
• 802.11n only: Only 802.11n wireless devices can connect to the network.
5.2.2 Security Setting
It is strongly recommended to enable the security settings to secure your network
from unauthorized access. Use the Security Setting page to configure the type of
security and encryption of your wireless network.
To access the Security Setting page, click SETUP > Wireless Settings > Security Setting
or click the Security Setting button.
Name (SSID) — Select the wireless network that you want to configure. Aside from
the main SSID, there are four virtual access points (VAP) that you can set the security
separately (see “MBSSID Settings” on page 43).
Wireless ADSL2+ Gateway 32
To Next Page
Loading...
Need help?
General
