Advanced
Wireless ADSL2+ Gateway 58
Rule Name — Enter a rule name or select an application name from the drop-down
n name,
Public Port — Enter the public port. This is the port seen from the WAN side.
Priv — Enter the private port. This is the port being used by applications
list on the right, then click the << button. If you select a predefined applicatio
the Public Port, Private Port, and Protocol Type are automatically configured.
DSL Interface — Select a DSL interface from the drop-down list.
ate Port
within your local network.
NOTE:
The public and private ports are usually the same.
Protocol Type — Select the protocol from the drop-down list.
IP Address — Enter the local network IP address of the system hosting the server.
Time Schedule — Select a schedule when to use the virtual server or click the New
Time Schedule button to create a new schedule.
your changes or click the Cancel button to discard your
. Port triggering is a type of port forwarding where outgoing data
e Port
The table displays the port triggers on your network. To edit an entry, click the
corresponding
Click the Apply button to save
changes.
6.8.2 Port Trigger
This page allows you to add port trigger rules and displays the port trigger settings
on your network
from specific ports are sent to specific incoming ports.
To access the Port Trigger page, click Advanced > NAT > Port Trigger or click th
Trigger button.
icon. To delete an entry, click the corresponding button.
To add port triggers, click the Add button. The Port Trigger Config screen is displayed.
Port Trigger — Check this box to enable port triggering.
Rule Name — Enter a rule name.
To Next Page
Loading...
Need help?
General
