Tektronix FG 5010 User Manual

7
1
П
П
c
П
П
n
П
n
C
C
TEST
Type :
Output
Syntax
:
TEST
Response :
TEST <
NUM >
;
Discussion
:
The TEST
command
causes the
FG 5010 to
perform self
tests . Those performed are the ROM tests , the serial I / O
hardware tests , and the AFC hardware integrity test ; and
are the same as
the tests
performed
during the
power - on
self
- test
sequence , except for
the RAM tests
. RAM tests
are
performed only at
power - on .
Signal output from the FG 5010 is disabled during test
execution . Previous settings are restored at completion of
testing . Test results are supplied as an output from the
FG 5010. A result of indicates that no failures were detect
ed . A detected failure causes an error code output that is
the same as that of power - on self - test failures . Refer to
Table 3-1 near the end of this section for event codes .
@
TEST
TRIANGLE
Type :
Setting only
Syntax :
TRIANGLE
Programming - FG 5010
Discussion :
The TRIANGLE command causes the FG 5010 output to
be
in triangular
waveform .
Selection of triangle
waveform
output
cancels any
previous
selection
. This
command
is a
special case of the FUNC command . The header ( FUNC ) is
optional , but
the argument
( TRIANGLE
) is not .
TRIANGLE
3-23

Tektronix FG 5010 Specifications

General

Brand	Tektronix
Model	FG 5010
Category	Portable Generator
Language	English