Command Descriptions
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-55
EXECute sets the oscilloscope to automatically provide a stable display of the
active edge--triggered waveform.
UNDO restores the oscilloscope settings to those present prior to the autoset
execution.
VIDeo Sets the oscilloscope to display a broadcast-standard video waveform
triggered on all lines. The video waveform must be NTSC, PAL, or SECAM-
compliant, with a horizontal scan rate from 15 kHz to 20 kHz.
VFields sets the oscilloscope to automatically provide a stable display of the
active video waveform, triggered on all fields. TDS3VID, TDS3SDI only.
VLines sets the oscilloscope to automatically provide a stable display of the
active video waveform, triggered on all lines. TDS3VID, TDS3SDI only.
AUTOSET EXECUTE
Autosets the oscilloscope to automatically acquire and display an edge-triggered
signal.
BELl (Set Only)
Emits an audible tone from the oscilloscope.
Miscellaneous
BELl
BELL
emits an audible tone from the oscilloscope.
BUSY? (Query Only)
Returns the status of the oscilloscope. This command allows you to synchronize
the operation of the oscilloscope with your application program. Synchronization
methods are described on page 3--7.
Status and error
BUSY?
Arguments
Examples
Group
Syntax
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
