Tektronix TDS3000 Series Program Manual

Command Descriptions
2-56
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
<NR1> = 0 means that the oscilloscope is not busy processing an execution-time-
intensive command. Execution-time-intensive commands are listed in
Table 2--29.
<NR1> = 1 means that the oscilloscope is busy processing one of the commands
listed in Table 2--29.
Table 2- 29: Commands that affect BUSY? response
Operation Command
Single sequence acquisition ACQuire:STATE ON or
ACQuire:STATE RUN
(when ACQuire:STOPAfter is set to SEQuence)
Automatic scope adjustment AUTOSet EXECute
Internal self--calibration *CAL
Hardcopy output HARDCopy STARt
BUSY?
might return 1, indicating that the instrument is busy.
*OPC, *WAI
CAL? (Query Only)
Returns the internal and factory calibration status and the calibration due status.
Calibration and Diagnostic
CAL?
Internal and factory calibration status and the calibration due status.
CAL?
might return :CALIBRATE:INTERNAL:STATUS PASS;:CALIBRATE:FACTORY:
STATUS PASS;NOTIFY:HOURS 2000;YEARS 1.0E0;DUE 0 to indicate the
internal and factory calibration status and the calibration due status.
Returns
Examples
Related Commands
Group
Syntax
Returns
Examples

Tektronix TDS3000 Series Specifications

General

Brand	Tektronix
Model	TDS3000 Series
Category	Test Equipment
Language	English