Section 3 - Configuring the VM700A
VM700A Option 01 (NTSC) & Option 11 (PAL) User Manual
3-9
Touch the icon representing the file to view it on the display. The file cannot
be edited, but can be scrolled through using the control knob.
The Time function allows you to set the VM700A internal calendar and clock
(shown in Figure 3-3) to the current time and date. The time and date are placed
on all printouts generated by the VM700A. Perform any or all the following
steps to enter the correct time and date into your VM700A.
ÎÎÎÎÎ
ÎÎÎÎÎ
ÎÎÎÎÎ
ÎÎÎÎÎ
ÎÎÎÎÎ
MO Aug 07 17:44:58 1995
Load
Time
Month
Aug
Date
07
Hour
17
Minute
44
Second
45
Year
1995
Tektronix
Figure 3-3: Time Configure menu
To Set the Time and Date. Select (touch) the Time soft key to display the
VM700A calendar and clock. The clock continues to run, but the numbers in the
soft keys do not advance with the time and display the time that was present
when the Time Configure menu was selected.
Select the Year, Month, Date, Hour, Minute, or Second soft key. Rotate
the control knob to set the year, month, date, hour, minute, or second. Set the
minute and second time (30 seconds or so) slightly ahead of the reference
clock time so that you can set the time exactly to your reference time.
Select the Load Time soft key to enter the new time and date at the exact
time you have set for the clock. This enters the time and restarts the clock at
that time.
Setting the Internal Clock
To Next Page
Loading...
Need help?
General
