Section 3 - Configuring the VM700A
VM700A Option 01 (NTSC) & Option 11 (PAL) User Manual
3-21
measurements within it are Selected. You must use the Create File function to
copy the contents of the System Default file into a new file, and then select the
new file before you can select a subset from the measurements available.
To Select or Unselect a Measurement. Open the Selected Measurements file for
editing by touching its icon in the display of the /nvrar0/ConfigFiles/
Selected_Measurements directory.
Scroll the file using the knob until the desired measurement is highlighted.
Note that the labels Selected and Not Selected are printed below the
directory window.
Touch the highlighted line on the Selected side of the screen to select the
measurement, or on the Not Selected side of the screen to deselect the
measurement.
If you wish to select only a small subset of the available measurements, press the
Select None soft key and then make your measurement selections.
If you wish to unselect only a small subset of the available measurements, press
the Select All soft key, then unselect the measurements of your choice.
Timed Events (Directory)
Files in the Timed Events directory provide a facility for producing scheduled
reports of Auto mode measurements, and performing operations (in the form of
functions to be played back) at specified times. Events occur at times specified
by the current Timed Events file. The Report Port setting in the Communication
Setup file must be set to Port 0 or Port 1, (not None) for reports to be generated.
To Next Page
Loading...
Need help?
General
