8-7
OPTIONAL DEVICES
Memory expansion
Installing memory module
To install a memory module, make sure the computer is in boot mode then:
1. Turn the computer off in boot mode. Refer to the Turning off the power
section in Chapter 3.
CAUTION: Do not remove the memory module while the computer is in
standby mode. The computer could hang up the next time you turn it on
and data in memory will be lost. In either of the above cases, the standby
configuration will not be saved.
The following message appears when you turn on the power:
WARNING: RESUME FAILURE.
PRESS ANY KEY TO CONTINUE.
If the computer hangs up when you turn it on, perform the following:
Press the power button and hold it down for five seconds, then turn the
power on again.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the Battery Pack (refer to Chapter
6, Power and Power-Up Modes.)
4. Remove two screws securing the memory module cover.
5. Lift off the cover.
NOTE: Use a point size 0 Phillips screwdriver.
Figure 8-7 Removing the cover
To Next Page
Loading...
Need help?
General
