Connecting
a
DVD
player
with
ColorStream®
(component
video),
a
VCR,
and
a
satellite
receiver
Your TV has two sets
of
ColorStream® (component video) inputs.
From
antenna
Stereo
VCR
~
VIDEO
A'""9,
-J,~=-
Ie
~
•
~
t
CH'l:f-
ANT
<@
~,
,_,.+OH'
OUT
10
TV
,
TV
lower
back
panel
AUDIO
OUT
~.c:lI:m=:D\..
~
r----
3E>O-+-----I-.=!!!:!:::~--------.J
l
re-rJ
l
~,I
PC
IN
ANT<!5r.1~
lfi~
~-,-,
AUDIO
'.
p,.", 0
~
i'"-'.-..-.-n-.
COMPONENT
VIDEO
S-VIOEQ
VIDEO
,$
OUT OUT
~
From
satellite
dish
~
Satellite
receiver
with
component
video
DVD
player
with
component
video
You will need:
• coaxial cables
• standard
AN
cables
- For better picture performance,
if
your
VCR
has S-video,
use an S-video cable (plus the audio cables) instead
of
the standard video cable.
00
not connect both types
of
video cable
to
VIDEO 1
at
the same time or the picture
performance will
be
unacceptable.
- Ifyou have a mono
VCR,
connect
UMaNa
on the
TV
to
your VCR's audio out terminal using the white audio cable
only.
• standard audio cables
• component video cables
-
You
can connect the component video cables (plus audio
cables) from the
OVO
player
or
satellite receiver
to
either
set
of
ColorStream terminals on the
TV
(HD-1
or
HD-2).
The
ColorStream HD·1
and
HD-2 terminals can
be
used
with Progressive
(4BOp,
720p)
and
Interlaced
(4BOi,
10BOi)
scan systems. A
1OBOi
signal will provide the
best
picture
performance
(1OBOp
is not supported).
- Ifyour
OVO
player
or
satellite receiver does not have
component video, connect a standard
AN
cable
to
VIDEO 2 on the side panel. Ifyour
OVO
player has
HoMI
video, see
page
17.
To view satellite programs usingthe component video
connections:
Tum
on the satellite receiver. Select the ColorStream HD-2
video input source on the TV.*
To view the VCR or view and record antenna
channels:
Tum
ON the VCR. Tune the VCR to the channel you want to
watch. Select the
VIDEO 1 video input source on the TV.*
To record a TV program while watching a DVD:
Turn ON the VCR. Tune the VCR to the channel to record.
Selectthe
ColorStream HD-1 video input source on the TV*
to view the DVD.
*
To
select the video input source, press INPUT on the remote control
(1& page 21).
To
program the
TV
remote control to operate other
devices, see Chapter
3.
The unauthorized recording, use, distribution, or revision of
television programs, videotapes, DVDs, and other materials is
prohibited under the Copyright Laws of the United States and
other countries, and may subject you to civil and criminal
liability.
To view antenna or Cable channels:
Select the
ANT
video input source on the TV.*
To view the DVD player:
Turn ON the DVD player. Select the ColorStream HD-1
video input source on the TV.*
15
I
To Next Page
Loading...
Need help?
General
