Clearing channels from the History List:
• Reconfiguring the ANT input will clear the History List.
Note: See
page
29
for details on configuring the antenna
input.
• Once 32 channels
or
inputs are stored in the History List, the
oldest item will be removed from the list when a new
channel or input is tuned.
•
If
History List in the Channel Browser Setup is set to
"Power Off Clear (On)," turning
off
the
TV
will clear the
History List.
Tuning
to
the
next
programmed
channel
To tune to the next programmed channel:
Press
(t,;)
or
~
on the remote control
or
TV
control panel.
Note:This feature will not work unless you program channels
into the
TV's
channel memory
(I@"
page
30).
Tuning
to
a
specific
channel
(programmed
or
unprogrammed)
Tuning analog channels:
Press the Channel Number
(0-9)
on the remote control. For
example, to select channel
125, press
1,2,5,
then
@.
Tuning digital channels:
Press the Channel Number
(0-9)
on the remote control,
followed by the dash
(@)
button and then the sub-channel
number. For example, to select digital channel
125-1, press
1,
2,5,
-,
1,
then@.
Note: If a digital channel is not
programmed-either
through
the automatic channel scan
(I@"
page
30)
or
the channel
add/
delete function
(I@"
page
30)-you
will have
to
tune the RF
channel using the Channel Number
and
dash
(@)
on the
remote control.
Switching
between
two
channels
using
Channel
Return
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1 Select the first channel you want to view.
2 Select a second channel using the Channel Number
buttons (and the dash
«(W)
button
if
selecting a digital
channel).
3 Press
CHOTN
on the remote control.
The
previous channel
will display. Each time you press
CH8N,
the
TV
will switch
back and forth between the last two channels that were
tuned.
Note: If you press
CH~
from a non-antenna input, the
TV
will return
to
the last-viewed input.
I 38
Switching
between
two
channels
using
SurfLock™
The
SurfLock™
feature temporarily "memorizes" one channel
to the
CH8N
button, so you can return to that channel quickly
from any other channel by pressing
CH~.
To
memorize a
channel to the
CH8N
button:
1 Tune the
TV
to the channel you want to program into the
CH~button.
2 Press and hold
CHOTN
for about 2 seconds until the message
"Channel Memorized" appears on-screen. The channel
has been programmed to the
CH~
button.
3 You can then change channels repeatedly, and when you
press
CON,
the memorized channel will be tuned.
The
TV
will return to the memorized channel one time only.
Once you press
CH8N
and then change channels again, the
CH
RTN memory will be cleared and the button will function as
Channel Return, by switching back and forth between the last
two channels that are tuned. This feature also works for
external inputs.
To Next Page
Loading...
Need help?
General
