Advanced
Picture
Settmgs
Mode
Preference
To
select the color
temperature:
NOise
Reduction
ANT
3 In the CableClear field, press
....
or
~
to select your
desired setting.
To change the CableClear settings:
Using
CableClear®
digital
noise
reduction
The CableClear® digital noise reduction feature allows you to
reduce visible interference
in
your TV picture. This may be
useful when receiving a broadcast with a weak signal
(especially a Cable channel) or playing a noisy video cassette
or disc.
1 Press
M~U
and open the Video menu.
2 Highlight Noise Reduction and press
@.
neutral
blueish
reddish
Medium
Warm
Cool
5 In the
Color
Temperature field, press
....
or
~
to select
the mode you prefer
(Cool, Medium, or Warm).
You can change the quality
of
the picture by selecting from
three presetcolor temperatures (Cool, Medium, and Warm), as
described below.
fMode
1 Press
M~U
and open the Video menu.
2 Highlight Picture Settings and press
@.
3 Highlight Advanced Picture
Settings
and press
@.
4 Highlight
Color
Te,mperature and press
@.
Selecting
the
color
temperature
6 Press ... or T to select either B Drive or G Drive, and
then press
....
or
~
to adjust the settings.
• B Drive:
~
makes the picture blueish.
• G Drive:
~
makes the picture greenish.
Note:
The
B
Drive
and
G Drive settings are connected to
the
Color
Temperature settings
and
will change
based
on which setting
is
selected
in
step 5 above.
7 To save the new settings, highlight Done and press
@.
To revert to the factory defaults, highlight Reset and
press@.
Note:
If
you select one
of
the factory-set picture modes
(Sports, Standard,
or
Movie)
and
then change the color
temperature mode, the picture mode automatically
changes
to
Preference.
Note:
• If the current input
is
ANT, VIDEO
1,
or
VIDEO
2,
the
menu will display the text "CableClear. "
The
available
selections are
Off, Auto, Low, Middle,
and
High.
• If the current input
is
ColorStream
HD1,
ColorStream
HD2, HDMI1, HDMI2,
or
HDMI3
the menu will display
the text
"ONR.
"
The
available selections are Off, Auto,
Low, Middle,
and
High.
Auto
will react proportionally
to
the strength
of
the noise. Low, Middle,
and
High will
reduce the noise
in
varying degrees, from lowest
to
highest, respectively.
4 To save the new settings, highlight Done and press
@.
To revert to the factory defaults, highlight Reset and
press@.
55
I
To Next Page
Loading...
Need help?
General
