Selecting
the
picture
mode
Adjusting
the
picture
Contrast
lower
higher
Back Light* darker
lighter
DynaLight** On/Off On/Off
Brightness
darker lighter
Color paler
deeper
Tint reddish greenish
Sharpness softer
sharper
Adjusting
the
picture
quality
You can adjust the picture quality (Contrast, Back Light,
DynaLight™, Brightness, Color, Tint, and Sharpness) to your
personal preferences.
Your personal preferences
Bright and dynamic picture (factory setting)
Standard picture settings (factory setting)
Lower contrast for darkened room (factory
setting)
Preference
Movie
Standard
Sports
You can select your desired picture settings from four different
modes, as described below.
To select the picture mode:
Press
PIC
~ODE
on the remote control.
The following popup menu appears on-screen.
Press
...
or
..
to select the picture mode you prefer and
press@.
To select the picture mode using the menu system:
1 Press
M~U
and open the Video menu.
2 Highlight Mode and press
@.
* Back Light
This feature adjusts the brightness of the entire screen. When
in
video mode and no signal
is
input, this will automatically be set to
O.
(Settings are stored
in
memory.)
**
DynaLight
This function automatically strengthens the black coloring of dark
areas
in
the video according to the level of darkness.
To adjust the picture quality:
1 Press
M~U
and open the Video menu.
2 Highlight Picture Settings and press
@.
3 Press
...
or
..
to select the picture quality you want to
adjust (Contrast, Back Light, DynaLight,
Brightness, Color, Tint,
or
Sharpness), and then
press
~
or
~
to adjust the setting, as described in the table
above.
3
Press'"
or
..
to select the picture mode you prefer and
press@.
Standard
Movie
Preference
Note:
The
picture mode you select affects the current
input only.
You
can select a different picture mode for
each input.
4 To save the new settings, highlight Done and press
@.
You can use any
of
the picture modes
(~
"Selecting the
picture mode," above left) as a starting point for adjusting
the picture settings.
To revert back to the base mode that you began adjusting
the picture settings from, highlight Reset and press
@.
The picture qualities you adjusted are automatically saved in
the Preference mode
(~
"Selecting the picture mode,"
above left) until Reset is selected.
I
42
To Next Page
Loading...
Need help?
General
