Viewing
the
digital
signal
meter
You can view the digital signal meter in the ANT digital TV
input source only.
To view the digital signal meter:
1 Press
M~U
and open the Setup menu.
2 Highlight Installation and press @.
3 A new set oflnstallation menu icons will appear, as shown
below. Open the
Terrestrial menu, highlight Signal
Meter,
and
press@.
4 Press'".......
~
to select the antenna input and digital
channel whose signal you want to check.
Note:
The
physical digital channel number listed
in
the
Signal Meter screen may not correspond
to
a virtual
TV
channel number. Contact your local broadcasters
to
obtain the RF channel numbers for your local digital
stations.
To close the screen
and
return
to the Terrestrial
menu:
Highlight Done and press
@.
To
return
to
normal
viewing:
Press
E~r
Viewing
the
system
status
---
To view the system status:
1 Press
M~U
and open the Setup menu.
2 Highlight Installation and press
@.
3 A new set oflnstallation menu icons will appear,
as
shown
below. Open the
System Status menu, highlight
System Information, and press
@.
4 Press
....
~
to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen
and
return
to the Installation
menu:
Highlight Done and press
@.
To
return
to normal viewing:
Press
E~r
Reset
Factory
Defaults
To reset all settings
and
channels to
their
factory
default values:
1 Press
M~U
and open the Setup menu.
2 Highlight Installation and press
@.
A new set
of
Installation menu icons will appear.
3 Open the System Status menu, highlight System
Information,
and press
@.
4 Press
....
~
to scroll through the menu bar to select
Factory Defaults.
5 Enter your PIN code (or 0000
if
no
PIN code has been set).
(continued)
33
I
To Next Page
Loading...
Need help?
General
