Setting
the
PC
Audio
This function allows you to output
or
mute the sound from
your PC when connecting using the PC IN terminal and
an
analog RGB cable.
(~
page 19)
To set the PC Audio:
1 Press
M~U
and open the Audio menu.
2 Highlight Audio Setup and press
8.
3 Press
...
or T to select PC Audio and then press
....
or
~
to select No
or
Yes.
Yes:
Outputs the sound from your
Pc.
No: Mutes the sound from your PC, and outputs the
sound from the HDMI-l (DVI) connection.
Note: Because the PC
and
HOMI-1 inputs share the same
set
of
analog audio inputs, the
PC
Audio menu setting
influences the
HDM/1
Audio menu setting. If
PC
Audio
is
set
to
"No,
" the
HDM/1
Audio setting changes
to
"Auto. "
If PC Audio
is
set
to
"Yes, " the
HDM/1
Audio setting
is
set
to
"Digital"
and
is
grayed out
in
the menu. (Also see
item 4 on
page
11
and
"Setting the
HOMI'M
Audio mode"
on
page
32.)
\
52
Setting
the
sleep
timer
You can set the sleep timer to tum
off
the TV after a set length
of
time (maximum
of
180 minutes).
To set the sleep timer using the remote control:
Press
soP
on the remote control to set the length
of
time until
the TV turns off. Repeatedly press S'tJEP to increase the time in
la-minute increments,
or
press'"
or T to increase or decrease
the time in lO-minute increments, to a maximum
of
180
minutes.
To set the sleep timer using the on-screen menus:
1 Press
M~U
and open the Setup menu.
2 Highlight Sleep Timer and press
8.
3 Press the Number buttons to enter the length
of
time in
lO-minute increments.
4 Highlight Done and press
8.
Note:
When
a power failure occurs, the sleep timer setting
may
be cleared.
To display the remaining sleep time:
Press S'tJEP.
Note: A message will display on-screen when there
is
one
minute remaining on the sleep timer.
To cancel the sleep timer:
Repeatedly press S'tJEP until it
is
set to a minute.
To Next Page
Loading...
Need help?
General
