Preparing
the
remote
control
for
use
Your
TV
remote control can operate your TV and many other
devices such as cable converter boxes, satellite receivers,
VCRs, DVDplayers, and HTIBs (home theater in a box), even
if
they are different brands.
If
you have a Toshiba device:
Your TV remote control is preprogrammed to operate most
Toshiba devices
(~
page 24).
If
you
have a non-Toshiba device or a Toshiba device
that the remote control is not
pre
programmed
to
operate:
You can program the
TV
remote control so it will operate the
other device
(~
pages 22-26).
Installing
the
remote
control
batteries
• Always remove batteries from the remote control ifthey are
dead
or
if
the remote control
is
not
to
be
used for an
extended period
of
time.
This
will prevent battery
acid
from
leaking into the battery compartment.
Remote
control
effective
range
For optimum performance, aim the remote control directly at
the TV and make sure there is no obstruction between the
remote control and the TV.
Point remote control
toward remote sensor
on
front of
TV.
Remove the battery cover from the back
of
the remote
control.
1
Squeeze tab
and lift cover.
o
o
16.4 ft (5m)
~.~.:
..•.•.
,
.•
~
2 Install two "AAA" size batteries, making sure to match
the +and- signs on the batteries to the signs on the battery
compartment.
3 Reinsert the battery cover in the remote control until the
tab snaps.
Caution: Never throw batteries into a
fire.
Note:
• Be sure to use AAA size batteries.
• Dispose
of
batteries
in
a designated disposal area.
• Batteries should always
be
disposed
of
with the
environment in mind. Always dispose
of
batteries
in
accordance with applicable laws
and
regulations.
• Ifthe remote control does not operate correctly,
or
if
the
operating range becomes reduced, replace batteries with
new ones.
• When necessary to replace batteries
in
the remote control,
always replace both batteries with new ones. Never mix
battery types
or
use new
and
used batteries
in
combination.
20
To Next Page
Loading...
Need help?
General
