Programming
channels
into
the
TV's
channel
memory
When you press
ft.;)
or
~
on the remote control or
TV
control
panel, your
TV
will stop only onthe channelsyou programmed
into the
TV's
channel memory.
Follow the steps below to program channels into the
TV's
channel memory.
Programming
channels
automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add
or
erase
individual channels in the channel memory.
Note:
•
You
must configure the antenna input source before
programming channels
(1&
page
29).
• If the Antenna inputsignaltype
is
setto Cable, the automatic
channel programming process erases channels that were
previously programmed into the
TV's
memory
• If the Antenna input signal type is set
to
Antenna, the
automatic channelprogramming process adds newly found
channels to the existing set
of
programmed channels (and
does NOT erase channels that were previously
programmed into the
TV's
memory)
To
remove an Antenna
source channel from the memory, you mustmanually delete
it.
•
To
tune the
TV
to a channel not programmed
in
the channel
memory, you must use the Channel Number buttons on the
remote control.
• Programming channels when the antenna input
is
configured for Cable will take substantially longer than when
the antenna input is configured for
Antenna.
This
is normal;
however, once channelprogramming
is
finished, you should
not
have
to
repeat the programming process again unless
your Cable
TV
service lineup changes significantly
To program channels automatically:
1 Configure the antenna input source,
if
you have not
already done so (1& page 29).
2 Press
M~U
and open the Setup menu.
3 Highlight Installation and press
@.
I
30
4 (A new set
of
Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Channel Program to bring up the Start, and press @
again to begin channel programming.
The TV will automatically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message "Scanning channels, please wait" appears (as
shown above).
5 To cancel channel programming, press
E~T
on the remote
control (or highlight Abort in the on-screen display and
press@).
When channel programming is finished, press
ft.;)
or
~
to
view the programmed channels.
Manually
adding
and
deleting
channels
in
the
channel
memory
After automatically programming channels into the channel
memory, you can manually add
or
delete individual channels.
To add
or
delete channels in the channel memory:
1 Press
M~U
and open the Setup menu.
2 Highlight Installation and press
@.
3 (A new set
of
Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Channel Add/Delete, and then press
@.
To Next Page
Loading...
Need help?
General
