e-STUDIO162/162D/151/151D SPECIFICATIONS 2 - 2
*1) May fluctuate due to environmental conditions and the input voltage.
3. Copy performance
∗
ADF/RADF: Optional
Duplex: e-STUDIO162D/151D
Fusing section Fusing system Heat roller system
Upper heat roller type Teflon roller
Lower heat roller type Silicon rubber roller
Heater lamp type Halogen lamp
Voltage 230V
Power consumption 800W
Electrical section Power source Voltage Local voltage
Frequency 50/60Hz
Rated current 8A
Power consumption Max. Less than 1000W
Average (during copying) 350 Wh/H *1)
Average (stand-by) 86Wh/H *1)
Pre-heat mode 25Wh/H *1)
Auto power shut-off mode 8.8Wh/H *1)
Section, item Details
Copy magnification Fixed magnification
ratios
4 Reduction + 3 Enlargement
(AB system : 25, 50, 70, 86, 100, 141, 200, 400%)
(Inch system : 25, 50, 64, 78, 100, 129, 200, 400%)
Zooming
magnification ratios
OC: 25 - 400%, ADF/RADF
∗
: 50 - 200%
(376 steps in 1% increments)
Manual steps (text, photo) 5 steps
Copy speed First copy time Tray paper feed 9.6 sec. (Pre-heat mode: 25 sec. / Auto power-shut-off mode: 40 sec.)
A4 or Letter/100%/Auto Exposure
AB system
A4
(Landscape)
Copy speed (CPM) Same size 15
Enlargement 15
Reduction 15
AB system
B5
(Landscape)
Copy speed (CPM) Same size 15
Enlargement 15
Reduction 15
Inch system
8-1/2" x 14"
(Landscape)
Copy speed (CPM) Same size 12
Enlargement 12
Reduction 12
Inch system
8-1/2" x 11"
(Landscape)
Copy speed (CPM) Same size 16
Enlargement 16
Reduction 16
Max. continuous copy quantity 99
Void Void area leading edge 1 - 4mm
Trailing edge 4mm or less, 6mm or less (Duplex copying/both image)
Side void area 0.5mm or more (per side)
4.5mm or less (total of both sides)
Image loss leading edge Same size: 3.0mm or less (OC) / 4.0mm or less (ADF/R-ADF/Duplex)
∗
Enlarge: 1.5mm or less (OC) / 3.0mm or less (ADF/R-ADF/Duplex)
∗
Reduction (50%): 6.0mm or less (OC) / 8.0mm or less (ADF/R-ADF/Duplex)
∗
Warm-up time 0 sec.
Power save mode reset time 0 sec.
Paper jam recovery time 0 sec.
Section, item Details
02_SPECI.fm 2 ページ ２００４年１２月２２日 水曜日 午後３時３７分
To Next Page
Loading...
Need help?
General