REMOVAL-INSPECTION-INSTALLATION
Rem~val.lnstallation Procedure
The installation procedure is the reverse of the removal procedure.
No.
1
Point Operations
2
3
4
5
6
[Point
I]
Item
Battery negative terminal
Removal:
Place a fuel tray under the pressure regulator.
Wrap a small piece of waste cloth around the union section,
and eliminate the fuel pressure by slowly loosening the union
bolt.
Note:
During the reassembly, use new gaskets and O-rings.
Throttle body
Elimination of fuel pressure in fuel system
Pressure regulator
Delivery pipe, spacer, and injector
Injector spacer
Caution:
Put waste cloth in order to prevent the fuel from
splashing.
Removal
DO
not allow any fire to come close during the operation.
See
P3-4
See P3-5
[Point
I]
See P3-5
Inspection Installation
t
t
[Point
21
t
t
[Point
51
[Point
41
[Point
31
To Next Page
Loading...
Need help?
General
